TAMS WD-34

4-way turnout decoder ( accessory decoders ) for DCC and Motorola. For switching of up to four turnouts with dual coil drive or up to eight other magnetic articles (eg semaphore signals and uncoupler ) . Ready-built module ( without case ) .

The four outputs can be mixed both DCC and Motorola commands as also during DCC and in Motorola format alternately .

Programming: With a DCC command station configuration variables (CVs ) are set . When using a Motorola central unit to set the decoder address, it is only possible with a programming button . The change of the other decoder features is not necessary for the pure Motorola operation and is not possible with Motorola central units.

Feedback : From the decoder RailCom messages can be forwarded over the rails to specific RailCom detectors.

Digital formats: DCC + MM ( automatic format detection )

Feedback protocol : RailCom

Address range: 1-2040 (DCC ) | 1-1020 (MM)

Supply voltage: via the control panel or a booster . To relieve the digital circuit, may alternatively use a separate transformer ( 14-18 V AC)

Switching Outputs : 4

Maximum current per output: 1,500 mA (up to 2 seconds)

Total maximum current: 1,500 mA

Board dimensions : 73 x 80 mm

Manual: http://www.tams-online.de/htmls/produkte/wd34/SD-34_WD-34_2008_DE.PDF